Ford TKX/TKO/Tilton 6000 SeriesSlip-on Hydraulic flat face Throw-Out bearing
Article: WHAT IS BEARING PRE-LOAD?
Using hydraulic technology from Tilton Engineering (Tilton 6000 Series), these new bearings are easy to install (slip over the bearing retainer of the transmission), and are built to last.The LF Series Internal Hydraulic Release Bearing is designed as a solution where the external slave causes interference or where no external kit has been developed. The light pedal feel of the LF Series is maintained with the added benefit of no clearance issues.
This is a Complete kit...........Not all Kits in the industry are created equal.................With MDL there are no extras to buy to install this upgrade.
The Modern Driveline Release Bearing kit includes:
- Hydraulic Release Bearing
- Stainless Steel adjustment Sleeve
- Steel braided supply and bleed lines
- Anti-rotation bolt and high-strength transmission retainer bolt
- Union fitting (connect to main supply line) In most cases 24" line is recommended. See below
FEATURES
- Billet aluminum body and piston precisionmachined in-house at Tilton
- Stainless steel threaded sleeve offers nearly 1.25" ofadjust-ability
- High-temperature mono-seal design features a quad tensioner to ensure proper seal tension and the highest reliability
- Constant contact design self-adjusts for clutch wear and maintains the same pedal feel throughout the clutch's life
- Newly designed swivel fittings have been thoroughly tested to ensure against leakage
Article: WHAT IS BEARING PRE-LOAD?
Using hydraulic technology from Tilton Engineering (Tilton 6000 Series), these new bearings are easy to install (slip over the bearing retainer of the transmission), and are built to last.The LF Series Internal Hydraulic Release Bearing is designed as a solution where the external slave causes interference or where no external kit has been developed. The light pedal feel of the LF Series is maintained with the added benefit of no clearance issues.
Compatibility extends to most bell housings. While the external slave only works with specific bell's, the internal style allows the use of other bells (ie: original 4-speed bells, big block bells.)
The adjustable sleeve allows nearly 1.25" of adjustment to accommodate a wide variety of clutches.The bearing height is adjustable from 1.77" to 3.00".Piston travel is a full 0.7"Bearing retainer guild tube size should measure 1.430"
NOTE: This will not work with a Big-input ToploaderA typical complete solution consists of the LF Series Master Clutch Kit, a steel braided line of appropriate length, and the LF Series Internal Hydraulic Release Bearing.
Kits are available for:
- Ford T5's, Ford TKO / TKX's.
- Ford T56's with CSC hydraulic setup already
- XL Magnum T56 for 2005+ Ford Mustangs